Block laying adhesive

Aerated concrete block adhesives are used to build walls made from aerated concrete blocks, particularly polished lime sand bricks or clinkers. Constructing such walls creates only small joints so the progress of construction work is faster and more efficient with this modern adhesion technology.

Tylose® grades prolong the open time and increase the adhesion strength.

Tylose Grades Product Characteristic Fact Sheet
MH 15002 P6 Final consistency : moderate » Read more
MHS 150003 P4 Final consistency : moderate » Read more
MHS 30024 P4 Final consistency : moderate » Read more

Building materials

» More information

Tylose® is an essential component in many building materials. It is mainly responsible for water retention, consistency and adhesion. The homogeneity, stability and workability of mortars are improved by the use of Tylose®. Using Tylose® enables the manufacturing of modern and efficient construction materials, such as machine plasters and thin bed adhesives.

Nomenclature Information
Type of ether Viscosity level Chemical refinement
M Methyl 60000

The viscosity level

is based on

Hoeppler: 2%

solution of the

commercial product

with 5% moisture

content, 20ºC,

20º dH

(German hardness)

Y Delayed solubility products
H Hydroxyethyl 30000 K Readily soluble granules
O Hydroxypropyl 15000 N non-delayed solubility products
A Allyl 10000 (only for Tylose H grades) *
X Hydrophobe 6000
etherification 4000 Degree of particle size
2000 Types of granules:
Degree of 1000 G4 Granules (< 500 μm)
B etherification 300 G6 Granules (< 400 μm)
F Special higher 200 G6 Granules (< 400 μm)
S degrees of . Powder types:
T etherification, . P2 Powder (< 180 μm)
depending on the . P3 Fine Powder (< 125 μm)
individual type of 01 P4 Fine powder (< 125 μm)
ether 02 P6 Ultra fine powder (< 100 μm)
03
04
.
.
.

* Tylose MH and MO Grades are not explicitly marked by ”N”, even if these products are ”non-delayed solubility products”.