Emulsion decorative render
Emulsion based renders are applied as surface finishes and have both a decorative and protective function. They are either applied in white or coloured. Alternatively, a colour coating can be applied afterwards. Additional structural effects can be obtained with emulsion based renders by different application techniques. These renders (also called stuccos) are often classified according to the application procedure: brush-applied, roller-applied or spray-applied render. Tylose® enhances the adhesion to the substrate and optimises sag resistance. Furthermore the addition of Tylose® brings elasticity, regulates the consistency and gives longer open time.
Tylose® MH grades with a low to medium viscosity level are normally used.
| Tylose Grades | Product Characteristic | Fact Sheet |
|---|---|---|
| HS 6000 YP2 | Final consistency :low | » Read more |
| MH 200 YP2 | Final consistency :very low | » Read more |
Building materials
Tylose® is an essential component in many building materials. It is mainly responsible for water retention, consistency and adhesion. The homogeneity, stability and workability of mortars are improved by the use of Tylose®. Using Tylose® enables the manufacturing of modern and efficient construction materials, such as machine plasters and thin bed adhesives.
| Nomenclature Information | |||||
|---|---|---|---|---|---|
| Type of ether | Viscosity level | Chemical refinement | |||
| M | Methyl | 60000 |
The viscosity level is based on Hoeppler: 2% solution of the commercial product with 5% moisture content, 20ºC, 20º dH (German hardness) |
Y | Delayed solubility products |
| H | Hydroxyethyl | 30000 | K | Readily soluble granules | |
| O | Hydroxypropyl | 15000 | N | non-delayed solubility products | |
| A | Allyl | 10000 | (only for Tylose H grades) * | ||
| X | Hydrophobe | 6000 | |||
| etherification | 4000 | Degree of particle size | |||
| 2000 | Types of granules: | ||||
| Degree of | 1000 | G4 | Granules (< 500 μm) | ||
| B | etherification | 300 | G6 | Granules (< 400 μm) | |
| F | Special higher | 200 | G6 | Granules (< 400 μm) | |
| S | degrees of | . | Powder types: | ||
| T | etherification, | . | P2 | Powder (< 180 μm) | |
| depending on the | . | P3 | Fine Powder (< 125 μm) | ||
| individual type of | 01 | P4 | Fine powder (< 125 μm) | ||
| ether | 02 | P6 | Ultra fine powder (< 100 μm) | ||
| 03 | |||||
| 04 | |||||
| . | |||||
| . | |||||
| . | |||||
* Tylose MH and MO Grades are not explicitly marked by ”N”, even if these products are ”non-delayed solubility products”.